Lovi, electric steam sterilizer with dryer
Description: The electric steam sterilizer allows you to quickly and conveniently disinfect feeding and baby care accessories. It can hold 5-6 bottles and other small accessories at the same time. Disinfection takes up to 8 minutes and the whole process uses only 75 ml of water. The sterilizer is simple and intuitive to use, operated with a single button. It is safe and automatically shuts down after disinfection. It has a specially designed filter container that facilitates the removal of water and impurities after the disinfection process is complete. It does not require the use of additional chemicals. The sterilizer comes with tongs that allow you to remove hot components. How to use: Before the first use, wash the inside of the sterilizer and its components and wipe it with a cloth. Decline! Do not submerge the body of the sterilizer in water! Perform the first empty sterilization to disinfect its interior. Pour 75 ml of water onto the heating plate. Place the base basket and then the bottle stabilizer on the structural shaft so that the necks of these elements touch. When placing the items to be disinfected, make sure that the steam can circulate efficiently over all surfaces and that the condensed water can flow easily into the filter container. Place the bottles on the structure upside down, passing them through the bottle stabilizer and placing them on the pins of the base basket. Then put the basket on the rod and lock it, then put all the accessories in it. Place this complex structure in the body of the sterilizer and put the lid on. Plug the device into the outlet and press the switch. Do not lift the cover while the device is operating. When finished, the sterilizer will automatically turn off. You will hear a beep 5 times to inform you that the process is complete; the control diode turns off. To remove the disinfected items, wait until the sterilizer cools down. It should cool for min. 3 minutes. Unplug the power cord and remove the cover. The contents of the sterilizer will remain sterile for up to 6 hours after the process is complete, provided the lid is not removed. Removed items must be used/discarded immediately after the process is completed or sterilized again. After using the device and removing the elements, open the protection of the filter container, remove the filter container, pour the remaining water after disinfection and rinse the container. Finally, wipe the inside of the body and container with a cloth to prevent limescale or deposits from forming. Decline! You can use the sterilizer again approximately 1 hour after the last disinfection. Remove the scale from the sterilizer every 4 weeks to ensure it is working effectively. Descaling can be done using a solution with citric acid or vinegar. Additional Information: The sterilizer is equipped with tongs that allow you to remove the hot elements. Once the process is complete, the sterilizer will automatically turn off. You will hear an acoustic signal to let you know that the process is complete and the indicator light will turn off. Keep the device in a box or in a clean and dry place. Never hide the sterilizer when it is dirty or wet, and never wrap the power cord around the device. Use boiled water for disinfection to minimize limescale build-up on the device. Do not use softened water in the sterilizer. Decline! In no case should you use other means than citric acid or vinegar to remove deposits, as this can cause irreversible damage to the product. Do not use corrosive substances or chemicals to clean the product. Do not use bleach solutions/tablets or chemical disinfectant in the sterilizer or on products to be disinfected in it.